Heritage Walnut Burl Block

A while back we made a Walnut Burl block flooring product that was perfectly smooth and square. It was beautiful material, so beautiful in fact that we held onto the off cuts to make this product for walls. Shown here unfinished.

  • Surfaces & Finishes:

    Heritage floors are finished with low VOC water based based polyurethane.

    SURFACE TREATMENTS include:

    • Sanded smooth

  • Dimensions & Formats:

    SOLID WOOD

    • Standard Thickness is 3/4″, custom thickness upon request
    • Board widths range from 3″ – 12″ wide,w ider boards available upon request
    • Board lengths are 2′ – 10′ random lengths, longer lengths available upon request

    ENGINEERED WOOD

    • Standard Thickness is 3/4″ or 5/8”, custom thickness upon request
    • Board widths range from 3″ – 12″ wide, wider boards available upon request
    • Board lengths are 2′ – 10′ random lengths, longer length groupings available upon request
    • 3/4″ thick engineered planks have a 6mm hardwood top layer
    • 5/8″ thick engineered planks have a 4.5 mm hardwood top layer

  • Installation Methods:

    Installation methods vary greatly depending on site conditions, but here are some general guidelines:

    • Solid wood is typically nailed, or nailed and glued, to a plywood subfloor.
    • Engineered wood is most commonly glued down to concrete subfloors. An additional soundproofing or moisture blocking barrier is often included in this type of installation.
    • Engineered floors are also usually the best choice for gluing down over radiant heat installations.
    • In either format, when planks are particularly wide, gluing and nailing is always good practice if possible.